UPS. Uninterruptible Power Supply. Output 5 KVA to 10 KVA. MINIpowerPLUS 10000
This Commercial MiniPower Plus 10000 has been protecting a server room but no longer required. This unit as it stands will give an output of 6KVA for approximately 2 hours.
The unit was running superbly the batteries are in good condition and of excellent quality. This UPS is loaded up with 5 Power modules in the Control Tower unit giving 6.25 KVA with space for a further 3 Power modules increasing the output to 10 KVA.
As shown in the photo of the inside of the Control Tower unit. The power modules are in excellent condition perfect running order for 6.25 KVA Output. In the matching Battery Tower unit their are 6 battery modules allowing the ability to increase the batteries by a further 4 Battery Modules thus increasing the battery autonomy. I have tried to show in the photos, 2 Battery modules in the bottom of the unit, 1 tray with 1 Battery module and 1 more tray with 3 Battery modules, both trays have been removed to make it lighter to handle, these just slide in and connect up following the blue tape markings I have put on. To increase the battery autonomy simply increase the amount of battery modules and fit on the vacant positions on the trays, the flying leads are already there ready for you to plug and play.
Each battery module contains 3off NPW45-12, 12v-45W batteries. This UPS System gives you the choice of increasing or decreasing the KVA Output as required, as well as the battery autonomy required its up to you what you want, you could start low and increase as your requirements alter at any time. The changing of batteries is very simple to do, I have taken the batteries out of the cabinet for ease of transportation due to the weight, they can be replaced at any time simply and cheaply.
Brief Manufacturers description about this system. The MINIpowerUPS 10000 is available in a tower version only and uses between four and eight 1250VA power modules to offer a system output of 5000VA, 6250VA, 7500VA, 8750VA or 10000VA. In this model range the batteries are contained in a separate battery cabinet which is similar in design and appearance to the UPS cabinet and is usually positioned adjacent to the UPS cabinet to form a matching suite. Cabinet size 270 x 475 x 570 each tower.
If required, additional battery cabinets can be connected to the existing battery cabinet to extend the systems autonomy time. Where increased autonomy is required several battery cabinets (up to 10) can be piggy-backed onto the basic system using a simple daisy chained inter-cabinet power cables. Battery autonomy is similarly flexible, and can be customised using battery kits.
The capacity of one string, containing three batteries is 9 Amp per hour. These can be standalone or integrated with the UPS power boards.
Full-load battery standby time of up to eight hours is available with a rapid recharge capability. Battery redundancy can also be built-in for guaranteed continuity of supply. For a full description of this system please search for. Also included in the sale 1phase MEM Memshield 3 distribution board, 10 way with 5 x 32A mcb and a 100 A double pole isolator switch, these can be upgraded to rcd if required. Also 2 lengths of flexibility conduit.
There is a hole at the bottom which would need to be blanked of for safety. You will be getting a great UPS system for a fraction of the normal cost. INSTUCTION MANUAL for Installation and operation of this UPS Is included.
PLEASE COLLECT IN PERSON DUE TO THE WEIGHT. Output 5 KVA to 10 KVA. MINIpowerPLUS 10000" is in sale since Friday, January 25, 2019.
This item is in the category "Computers/Tablets & Networking\Power Protection, Distribution\Uninterruptible Power Supplies". The seller is "jensaac" and is located in Leicester. This item can't be shipped, the buyer must pick up the item.
- Brand: MINIpowerPLUS
- Model: MINIpowerPLUS 10000
- Max. Voltage-Amps: 10000 VA
- Type: Enterprise/Data Center UPS
- Voltage Compatibility: 230 V
- Features: Audible Alarm