MGE 10A Maintainance bypass switch PDU Manual source selector 3400794000
2x C19 input, one for mains and one for the UPS return. 1x C19 output to feed into the UPS then there is an set of output sockets to supply power to other devices. 6x C13 type 1x C19 type I'll explain how to use these as its not always obvious. The device allows you to supply the output sockets from either of the input sources - either just the mains, or the UPS source.You plug the mains power into the bypass selector. Then you supply power to your UPS from the blue ringed "UPS IN" C19, if you want to. You can also supply power to your UPS from a different cable you dont have to use this.
Then you plug the UPS output back into the bypass selector - the red ringed "UPS OUT" C19 socket. Then the Bypass switch has power coming both from mains and the UPS and you can select which to draw from using the selector switch. There are LED's to show power presence and alart when running on bypass (with the UPS out of the loop). Of course they are a switch at heart and can be used for anything or DIY projects that need a 10 Selecter switch / input socket selection / PDU. The units are fully tested by UPS experts, and are fully working.
Under normal circumstances most orders before 3PM are dispatched on the day of order. Large units / quantities may roll over to being dispatched the next day.We try to meet all customer deadlines. All of our consignments are sent fully insured on a 24 hour service with our carriers. We cover all problems that occur in transit. We have the packing materials to make sure that there are few problems in transit. Our warehouse is based in the UK. HotSwap MBP provides a maintenance bypass for all UPSs up to 3 kVA: UPSs can be hot swapped or upgraded without interrupting the power supply HotSwap MBP has an IEC16A input connector with retaining clip for compatibility with any UPS now and in the future from Eaton or any other supplier There is a range of HotSwap MBP units with different output connectors: Aust 3 pin and IEC sockets - terminal blocks on the HW (Hard-Wired) version HotSwap MBP units can be installed as required; at the back, side, top of the UPSs, or rack-mounted horizontally (1.5U) or vertically. The item "MGE 10A Maintainance bypass switch PDU Manual source selector 3400794000" is in sale since Tuesday, December 4, 2018. This item is in the category "Computers/Tablets & Networking\Power Protection, Distribution\Uninterruptible Power Supplies". The seller is "ups-trader" and is located in Manchester, Lancashire. This item can be shipped worldwide.
- Type: bypass switch
- MPN: 3400794000
- Brand: MGE