APC SMART UPS SURT2000XLI Uninterruptible Power Supply Used 1400W 9.1A
APC SMART UPS SURT2000XLI Uninterruptible Power Supply Used 1400W 9.1A. With a load test of 2.6amps; autonomy was just over 4 minutes. Front cosmetic cover is not included. Avoids costly power problems by keeping your IT equipment and data protected and available. Network grade power conditioning protects from damaging surges and disruptive noise. The double conversion architecture provides tight voltage regulation, frequency regulation, and zero transfer time to battery during power events. Peace of mind that comes with full equipment compatibility and reliability of a leader. Provides pure sine wave output which is recommended by server manufacturers using active power factor corrected (PFC) power supplies. Safety agency tested and approved means that you can deploy Smart-UPS with confidence that they meet or exceed the industrys most rigorous standards.
Intelligent battery management, pioneered by APC, maximizes battery performance and life through intelligent, precision temperature compensated charging. Automatic self-tests insure battery reliability and warn customers in advance of battery replacement. Convenient, easy to connect, hot-swappable battery modules provide battery replacement without powering down. Quickly understand unit and power status with visual indicators. Customize UPS capabilities with management cards.
Enables centralized management via the APC InfraStruXure Manager. Provides management of the UPS via a serial port.
Provides remote power management of the UPS over the network. Prolongs battery life by regulating the charge voltage according to battery temperature. Maximizes battery performance, life, and reliability through intelligent, precision charging.Automatic restart of loads after UPS shutdown. Automatically starts up the connected equipment upon the return of utility power. Ensures clean, uninterrupted power to protected equipment while batteries are being replaced.
Supplies utility power to the connected loads in the event of a UPS power overload or fault. Allows additional run time to be quickly added as needed.Increases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR). Periodic battery self-test ensures early detection of a battery that needs to be replaced. Provides early-warning fault analysis ensuring proactive component replacement. Warns when a battery is not available to provide backup power. Provides notification of changing utility power and UPS power conditions. Ensures clean, uninterrupted power to protected equipment when generator power is used. Minimizes installation costs by enabling the use of smaller generators and cabling. Protects connected loads from surges, spikes, lightning, and other power disturbances. Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment. Easy recovery from overloads; no need to replace a fuse. Gives higher application availability by correcting poor frequency and voltage conditions without using the battery. Provides temporary battery power when the utility power is out. Protects the initial investment in the UPS when migrating from tower to rack-mount environment. Install maintenance releases of firmware remotely using FTP. Ensures clean, uninterrupted power to the loads when adding extra runtime to the UPS. Output power capacity 1.4 KWatts / 2.0 kVA. Max Configurable Power (Watts) 1.4 KWatts / 2.0 kVA. Output Voltage Note Configurable for 220 : 230 or 240 nominal output voltage. Output Voltage Distortion Less than 3%.
Filtering Full time multi-pole noise filtering : 0.3% IEEE surge let-through : zero clamping response time : meets UL 1449. Maximum Height 432mm , 43.2CM. Maximum Width 85mm , 8.5CM.Maximum Depth 483mm , 48.3CM. Operating Temperature 0 - 40 °C. Operating Relative Humidity 0 - 95% non-condensing %. Storage Temperature -20 - 50 °C. Storage Relative Humidity 0 - 95% non-condensing %.
Audible noise at 1 meter from surface of unit 50.0dBA. Online thermal dissipation 543.0BTU/hr. Approvals C-tick, CE, EN 50091-1, EN 50091-2, EN 55022 Class A, EN 60950, EN 61000-3-2, GOST, VDE.Thank you for looking at our items! This will not affect any actions you may take at a later date but it does give us the opportunity to assist you in any way we can, as we strive to deliver a service worthy of 5 at all times.
- Brand: APC
- EAN: Does not apply
- Max.Wattage: 1400 W
- MPN: RT-2000