APC Smart-UPS RT 15kVA 12KWatts RM 230V UPS + Network Manage Card SURT15KRMXLI
APC Smart-UPS RT 15kVA 12KWatts RM 230V UPS + Network Manage Card SURT15KRMXLI. APC Smart-UPS RT 15kVA RM 230V. UPS only - no batteries included. 1 x APC Smart-UPS RT 15kVA 12KWatts RM 230 V UPS SURT15KRMXLI.
1 x APC AP9619 Network Manage Card EM 10/100 Base-T. Serial connectivity - Provides management of the UPS via a serial port. LED status indicators - Quickly understand unit and power status with visual indicators. SmartSlot - Customize UPS capabilities with management cards. InfraStruXure Manager Compatible - Enables centralized management via the APC InfraStruXure Manager. Network manageable - Provides remote power management of the UPS over the network.
Hot-swappable batteries - Ensures clean, uninterrupted power to protected equipment while batteries are being replaced. Automatic restart of loads after UPS shutdown - Automatically starts up the connected equipment upon the return of utility power.
Temperature-compensated battery charging - Prolongs battery life by regulating the charge voltage according to battery temperature. Automatic internal bypass - Supplies utility power to the connected loads in the event of a UPS power overload or fault. Intelligent battery management - Maximizes battery performance, life, and reliability through intelligent, precision charging.
Scalable runtime - Allows additional run time to be quickly added as needed. Audible alarms - Provides notification of changing utility power and UPS power conditions.
Predicitive failure notification - Provides early-warning fault analysis ensuring proactive component replacement. Disconnected battery notification - Warns when a battery is not available to provide backup power. User-replaceable batteries - Increases availability by allowing a trained user to perform upgrades and replacements of the batteries reducing Mean Time to Repair (MTTR). Automatic self-test - Periodic battery self-test ensures early detection of a battery that needs to be replaced.
Flash upgradeable firmware - Install maintenance releases of firmware remotely using FTP. Rack/Tower convertible - Protects the initial investment in the UPS when migrating from tower to rack-mount environment. Plug-and-Play external batteries - Ensures clean, uninterrupted power to the loads when adding extra runtime to the UPS.
Frequency and voltage regulation - Gives higher application availability by correcting poor frequency and voltage conditions without using the battery. Input power factor correction - Minimizes installation costs by enabling the use of smaller generators and cabling. Cold-start capable - Provides temporary battery power when the utility power is out. Power conditioning - Protects connected loads from surges, spikes, lightning, and other power disturbances.
Resettable circuit breaker - Easy recovery from overloads; no need to replace a fuse. Safety-agency approved - Ensures the product has been tested and approved to work safely with the connected service provider equipment and within the specified environment. Generator compatible - Ensures clean, uninterrupted power to protected equipment when generator power is used. Output power capacity - 12.0 KWatts / 15.0 kVA. Max Configurable Power (Watts) - 12.0 KWatts / 15.0 kVA. Nominal Output Voltage - 230V. Output Voltage Note - Configurable for 380 : 400 or 415 V 3 Phase nominal output voltage. Output Voltage Distortion - Less than 5%. Output Frequency (sync to mains) - 50/60 Hz +/- 3 Hz user adjustable +/- 0.1.
Other Output Voltages - 220, 240. Load Crest Factor - 3 : 1.
Topology - Double Conversion Online. Waveform type - Sine wave. (8) IEC 320 C19 (Battery Backup).
(1) Hard Wire 3-wire (H N + G) (Battery Backup). (2) IEC Jumpers (Battery Backup). Bypass - Built-in Static Bypass, Internal Bypass (Automatic and Manual), Optional External Bypass.
Nominal Input Voltage - 230V , 400V 3PH. Input frequency - 40-70 Hz (auto sensing). Input Connections - Hard Wire 3 wire (1PH+N+G), Hard Wire 5-wire (3PH + N + G).
Input voltage range for main operations - 160-280V. Input Total Harmonic Distortion - Less than 5% for full load.
Other Input Voltages - 220, 240. Maximum Input Current - 90.0A. Input Power Factor at Full Load - 0.95. Interface Port(s) - DB-9 RS-232 , RJ-45 10/100 Base-T , Smart-Slot. Pre-Installed SmartSlot Cards - AP9631.
Control panel - Multi-function LCD status and control console. Audible Alarm - Audible and visible alarms : configurable delays. Emergency Power Off (EPO) - Yes. Filtering - Full time multi-pole noise filtering : 0.3% IEEE surge let-through : zero clamping response time : meets UL 1449. Maximum Height - 533mm , 53.3CM.
Maximum Width - 432mm , 43.2CM. Maximum Depth - 773mm , 77.3CM. Net Weight - 247.73KG. Operating Temperature - 0 - 40 °C. Operating Relative Humidity - 0 - 95% non-condensing %. Storage Temperature - -15 - 45 °C. Storage Relative Humidity - 0 - 95% non-condensing %. Audible noise at 1 meter from surface of unit - 50.0dBA. Online thermal dissipation - 2800.0BTU/hr. Protection Class - IP 20. VAT IS NOT PAYABLE BY PURCHASERS OUTSIDE THE European Union (EU) AND by. Purchasers in the EU (excluding UK) who are VAT registered.
The item "APC Smart-UPS RT 15kVA 12KWatts RM 230V UPS + Network Manage Card SURT15KRMXLI" is in sale since Friday, April 20, 2018. This item is in the category "Computers/Tablets & Networking\Power Protection, Distribution\Uninterruptible Power Supplies".
The seller is "itinstock" and is located in North London. This item can be shipped worldwide.
- Surge Energy Capacity: 5000VA
- Voltage Compatibility: 110V
- Max. Voltage-Amps: 5000VA
- Brand: APC
- MPN: SURT15KRMXLI AP9619
- Type: Enterprise/Data Center UPS
- Model: APC Smart-UPS RT 15kVA RM 230V
- Waveform Type: Sine wave
- Input Connections: Hard Wire 3 wire (1PH+N+G), Hard Wire 5-wire (3PH
- UPS Runtime: 8.3 min (12000 Watts) 22.3 min (6000 Watts)
- Features: Network Manageable
- Topology: Double Conversion Online